Using the MonsterMux 32:
Parts you will need:
- Arduino Duemilanove or MEGA
- Completed MonsterMux32 Shield
- Analog voltage source
- Demo Sketch for Arduino
Testing:
Open the demo code in the Arduino environment and upload it to the Arduino.
The code will read the selected analog channel and output the value over the serial port.
Connect the positive output of the analog voltage source to channel 23, and ground to the GND terminal block. Run the code and verify that the output corresponds to the analog source voltage.
Try changing the channel selection in the code and moving the analog source to a different channel. Verify the correct output.
We hope you enjoyed building and using the MonsterMux32!
|
