Independently control 2 solenoid valves using a 0 - 5 volt analog input signal or any 1k to 30k pot. Each channel is capable of 5 amps of continuous current. It can also be used for small motors and lamps.

Features:

• Use any 1k to 30k pot for control
• Selectable PWM Frequency to better match your valves
• Logic Controller Enable input
• High efficiency MOSFET design for cool operation

Specifications:

• 5 Amps continuous current per channel
• 6 - 26 VDC operation
• 0-5 V Control Voltage, 0-10 V or 4-20 ma control versions available
• Configurable PWM Frequencies: 200Hz, 400Hz, 800Hz, 1.5kHz, 3kHz, 6kHz, 12kHz, 24kHz
• PWM Range: 0% - 100%

Connections:

• Terminal blocks for signal and power connections. (Pluggable Terminal Block Header Option also available)

Technical Documents:

Datasheet (PDF)

Application Notes:

Keep wiring as short as possible, especially between the controller and the power supply.
When choosing a controller based on your input voltage requirements, please note that a fully charged 12V nominal lead-acid battery can reach 14 volts. Please check to ensure that the battery pack voltage does not ever exceed the absolute maximum rated voltage of the motor controller.

Dimensions:

2.0 x 3.0 x 0.75 inches tall.